|
| Welcome to the QualityWings Forums! Ultimate 787 Owners who are new to our Support system: DO NOT POST SUPPORT REQUEST IN THE GENERAL FORUMS! You must register your product by going here first. |
Avro RJ VNAV Cruise Target Speed works only Mach |
Post Reply 
|
| Author | |
MagicD3VIL 
Licensed Member 
Joined: 12 Sep 2018 Status: Offline Points: 14 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Avro RJ VNAV Cruise Target Speed works only MachPosted: 11 Aug 2022 at 5:45pm |
|
For some reason when setting up VNAV CRZ TGT SPD with input of "270" the knots value is always ignored and the mach value behind the slash is used. I can set it to "120/0.60" and while crusing the VNAV will hold ~272 knots. Has anyone else noticed this? I would expect that the knots value would get translated to mach value behind the slash.
Cheers |
|
 |
|
|
MagicD3VIL
Licensed Member
Joined: 12 Sep 2018 Status: Offline Points: 14 |
Post Options
Thanks(0)
Quote Reply
Posted: 12 Aug 2022 at 5:46pm |
|
I noticed that while in VNAV cruise phase, the display shows "A/T MACH", which is the reason why the mach speed is used. Hovewer, pressing the C/O button shows "A/T IAS" on the display for just a second and then it switches itself back to "A/T MACH".  All of the other modes like Thrust and Lvl Change work normally. After pressing the C/O button they stay in the selected "A/T IAS" or "A/T MACH" modes normally. I still do not know why this is a problem only with VNAV in the cruise phase. VNAV Climb and Descent phases use the IAS values normally. |
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options